EC:A8:6B:F9:1E:F9


DEVICE=eth0
# change the hardware address to match the hardware address your NIC uses
HWADDR=EC:A8:6B:F9:1E:F9
ONBOOT=yes
BRIDGE=br0
NM_CONTROLLED=no

DEVICE=br0
TYPE=Bridge
BOOTPROTO=static
IPADDR=192.168.1.101
NETMASK=255.255.255.0
GATEWAY=192.168.1.1
ONBOOT=yes

# system-config-firewall-tui 

# yum install ntp

# chkconfig ntpd on
# service ntpd start
# hwclock --systohc
/etc/sysctl.conf


yum install http://downloads.eucalyptus.com/software/eucalyptus/3.4/centos/6/x86_64/eucalyptus-release-3.4.noarch.rpm -y
yum install http://downloads.eucalyptus.com/software/euca2ools/3.0/centos/6/x86_64/euca2ools-release-3.0.noarch.rpm -y
yum install http://downloads.eucalyptus.com/software/eucalyptus/3.4/centos/6/x86_64/epel-release-6.noarch.rpm -y

# yum install eucalyptus-nc
# yum install eucalyptus-cloud eucalyptus-cc eucalyptus-sc eucalyptus-walrus openssh -y
# service sshd start
# chkconfig sshd on

/usr/sbin/euca_conf --initialize
service eucalyptus-cloud start
service eucalyptus-cc start
service eucalyptus-nc start

/usr/sbin/euca_conf --register-walrus --partition walrus --host 192.168.1.101 --component walrus-cloud
/usr/sbin/euca_conf --register-cluster --partition cluster01 --host 192.168.1.101 --component cc-cloud
/usr/sbin/euca_conf --register-sc --partition cluster01 --host 192.168.1.101 --component sc-cloud
/usr/sbin/euca_conf --register-nodes "192.168.1.101"




euca-modify-property -p cluster01.storage.blockstoragemanager=overlay